Introduction

To use KWP2000Plus ECU Flasher is used to READ & WRITE the flash data stored on modern ECU's. This data contains MAPS which are responsible for ignition advance, injection timing, torque limiter, speed limiter and more. By reading the data and using a proper program you can find these MAPS and alter the values. (e.g. increase power by massive amounts)

Connects to USB
Supports high speed ECU flashing
Led Indications for power/rx/tx
Can read and write a lot more ECU's than the normal KWP2000 Software

Very easy to use:

- install the driver package to your notebook/pc
- connect the ecu-flasher to a free USB port
- point windows to the folder where you installed the driver package
- reboot

How to read data from a supported ECU:

- connect the hardware to your USB port & to the diagnostic port of the car
- start the communication software
- turn ignition on (not engine, just the ignition only)
- select the ECU you want to read/write from a list
- select additional options (if needed)
- click the read button to read out the original data (where supported)
- save the file to you HD, edit or forward it

How to write data to a supported ECU:

- connect the hardware to your USB port & to the diagnostic port of the car
- start the communication software
- turn ignition on (not engine, just the ignition only)
- select the ECU you want to read/write from a list
- select additional options (if needed)
- click the write button and select the file you want to write
- follow the instructions on screen
- switch off ignition and wait 10 seconds. done.

fully plug&play so no need to worry about installation.

Package includes

KWP 2000 PLUS Interface.
20 PIN BMW connector.
38 PIN Mercedes Benz connector.
Shielded USB A to USB B connection cable.
Universal OBD2 connector.
12 Volt lighter to banana cable.
CD with drivers & software
Printed Instructions with screen shots for ease.