Introduction

The Galletto Flasher is used to READ & WRITE the flash data stored on the latest ECU's. This data contains MAPS which are responsible for ignition advance, injection timing, torque limiter, speed limiter and more. By reading the data and using a proper program you can find these MAPS and alter the values. (e.g. increase power by massive amounts)

GALLETTO EOBD2 is easy hardware for updating software (typical chiptunning) Working on EDC16, EDC15, MEx.x , DELCO and many more engine ECUs.

It is compatible with the newest modern diesel TDi,HDi,JTD, etc and petrol cars.

Very easy to use:

- install the driver package to your notebook/pc
- connect the ecu-flasher to a free USB port
- point windows to the folder where you installed the driver package
- reboot

How to read data from a supported ECU:

- connect the hardware to your USB port & to the diagnostic port of the car
- start the communication software
- turn ignition on (not engine, just the ignition only)
- select the ECU you want to read/write from a list
- select additional options (if needed)
- click the read button to read out the original data (where supported)
- save the file to you HD, edit or forward it

How to write data to a supported ECU:

- connect the hardware to your USB port & to the diagnostic port of the car
- start the communication software
- turn ignition on (not engine, just the ignition only)
- select the ECU you want to read/write from a list
- select additional options (if needed)
- click the write button and select the file you want to write
- follow the instructions on screen
- switch off ignition and wait 10 seconds. done.

Package includes

ECU Flasher interface
OBDII Connector
Software & Drivers CD